1. Producto terminadoview
The Somfy Telis 4 RTS Pure Remote is a 5-channel radio remote control designed for operating Somfy RTS motorized window coverings. It enables individual or group control of up to five window coverings or groups of coverings. This remote also features a 'my' button for memorizing and recalling a favorite position. Its ergonomic design and durable rubber edging ensure comfortable and long-lasting use.

2. Configuración
2.1 Instalación de la batería
The Telis 4 RTS Pure Remote requires one CR2 battery. To install or replace the battery:
- Ubique el compartimiento de la batería en la parte posterior del control remoto.
- Abra con cuidado la tapa del compartimento.
- Inserte una batería CR2, asegurándose de la polaridad correcta (+/-).
- Cierre bien la tapa del compartimento de la batería.
2.2 Pairing with RTS Motors
To pair the Telis 4 RTS Pure Remote with your Somfy RTS motor, follow these general steps. Specific procedures may vary depending on your motor model; refer to your motor's instruction manual for precise details.
- Ensure the Somfy RTS motor is powered on and in programming mode. This often involves a brief power cycle of the motor (unplugging and replugging), or pressing a program button on an existing remote or directly on the motor.
- On the back of the new Telis 4 remote, locate the small program button.
- Press and hold the program button on the new remote until the motor jogs (moves slightly up and down). This indicates successful pairing.
- Test the remote by pressing the 'Up' or 'Down' buttons to confirm control.

3. Instrucciones de funcionamiento
3.1 Selección de canales
The Telis 4 RTS Pure Remote can control up to five individual window coverings or groups of coverings. To select a channel:
- Press the channel selection button (the large round button at the bottom front of the remote) repeatedly.
- The indicator lights above the button will illuminate to show the currently active channel (1-5).
- Select the desired channel before sending commands.
3.2 Up/Down Control
Once a channel is selected:
- Presione el Flecha hacia arriba button to raise the window covering.
- Presione el Flecha hacia abajo button to lower the window covering.
- Press either the Up or Down arrow button again to stop the covering at its current position.
3.3 'My' Button Function
The 'my' button serves two primary functions:
- Función de parada: Durante el movimiento, presione el 'my' button to stop the window covering at its current position.
- Posición favorita: If a favorite position has been programmed, press the 'my' button to move the covering to that pre-set position.
To Set a Favorite Position:
- Move the window covering to your desired favorite position using the Up or Down arrow buttons.
- Mantenga pulsado el 'my' button until the window covering jogs. This confirms the favorite position has been saved for the selected channel.

4. Mantenimiento
4.1 Reemplazo de batería
If the remote's operational range decreases or it becomes unresponsive, the battery may need replacement. Refer to section 2.1 for battery installation instructions.
4.2 Limpieza
Clean the remote control with a soft, dry cloth. Avoid using abrasive cleaners, solvents, or excessive moisture, as these can damage the remote's electronics or finish.
5. Solución de problemas
- El control remoto no responde:
- Check if the battery is correctly installed and has sufficient charge. Try replacing the CR2 battery.
- Ensure the remote is within the maximum operating range of 65 feet from the Somfy RTS motor.
- Verifique que esté seleccionado el canal correcto en el control remoto.
- Motor not responding to remote commands:
- Check the power supply to your Somfy RTS motor. Ensure it is receiving power.
- Attempt to re-pair the remote with the motor following the instructions in section 2.2.
- If you have multiple remotes, test with another known working remote to isolate the issue.
- Window covering stops unexpectedly or does not reach limits:
- This may indicate an issue with the motor's limit settings. Refer to your specific motor's instruction manual for details on adjusting limit settings.
- Ensure no obstructions are preventing the covering from moving freely.
6. Especificaciones
| Característica | Detalle |
|---|---|
| Marca | Somfy |
| Nombre del modelo | Telis 4 RTS Pure Remote |
| Número de modelo | 1810633 |
| Tecnología de conectividad | Radiofrecuencia (RTS) |
| Número de canales | 5 |
| Tipo de batería | Batería 1 x CR2 |
| Alcance máximo | 65 pies (20 metros) |
| Característica especial | Diseño ergonómico |
| Color | Puro |
7. Información de garantía
Warranty information for the Somfy Telis 4 RTS Pure Remote (Model 1810633) is typically provided with your purchase documentation or can be found on the official Somfy website. Please retain your proof of purchase for warranty claims. For detailed terms and conditions, refer to the manufacturer's official warranty policy.
8. Soporte
Para obtener más ayuda, soporte técnico o para consultar sobre productos Somfy adicionales, visite el sitio web oficial de Somfy. website or contact their customer service department. You can often find helpful resources, FAQs, and contact information on their support pages.
- Somfy Oficial Websitio: www.somfy.com
- Servicio al cliente: Consulte la webSitio para información de contacto regional.