WAC Lighting TK-103LED Line VoltagManual de instrucciones del cabezal de seguimiento electrónico

1. Introducción

This manual provides detailed instructions for the safe installation, operation, and maintenance of your WAC Lighting TK-103LED Line Voltage Track Head with 8W GU10 LED Bulb. Please read all instructions carefully before installation and retain this manual for future reference. This product is designed for indoor use only.

2. Información de seguridad

ADVERTENCIA: Para reducir el riesgo de incendio, descarga eléctrica o lesiones a las personas, tenga en cuenta lo siguiente:

• Ensure power is turned off at the circuit breaker before installation or servicing.
• Todas las conexiones eléctricas deben cumplir con los códigos y ordenanzas locales o el Código Eléctrico Nacional (NEC). Consulte a un electricista calificado si no está familiarizado con las conexiones eléctricas correctas.
• No instale este accesorio en un lugar húmedo o seco.amp locations. This product is rated for dry locations only.
• Do not attempt to alter or modify the fixture. Any alterations may void the warranty and create a safety hazard.
• Advertencia sobre la Proposición 65: Este producto puede contener sustancias químicas conocidas en el estado de California como causantes de cáncer y defectos de nacimiento u otros daños reproductivos.

3. Producto terminadoview

The WAC Lighting TK-103LED is a line voltage track head designed for use with 120V track systems. It features a durable formed metal construction with a polycarbonate track adaptor and includes an 8W GU10 LED bulb. The fixture offers versatile aiming with 350-degree horizontal rotation and 90-degree vertical tilt, allowing for precise light direction.

Figura 1: Dimensiones del producto
This diagram illustrates the dimensions of the WAC Lighting TK-103LED track head. The fixture measures approximately 4 11/16 inches in height when pointed downwards, and 5 7/16 inches when angled. The base width is 3 1/16 inches. The track adapter section is 1 3/8 inches wide and 1 1/8 inches high. The light head itself is 2 5/8 inches deep.

4. Configuración e instalación

This track head is designed for ceiling mount installation on 120V track systems. It is compatible with H, J/J2, and L track configurations. Ensure you have the correct track type for your installation.

4.1 Componentes incluidos

• Track fixture (with pre-installed 8W GU10 LED bulb)
• Instrucciones de instalación

4.2 pasos de instalación

1. Apagar la energía: Before beginning installation, ensure the power to the track system is completely OFF at the circuit breaker.
2. Identificar el tipo de pista: Verify your track system is a 120V H, J/J2, or L type track. The track head adaptor is designed to fit these specific types.
3. Insertar cabezal de pista: Align the track head adaptor with the track slot. Push the adaptor firmly into the track and twist it to lock it into place. Ensure the electrical contacts on the adaptor engage properly with the track conductors.
4. Accesorio seguro: Tighten any aiming screws or locking mechanisms on the track adaptor to secure the fixture's position on the track.
5. Restaurar energía: Una vez que el artefacto esté instalado de forma segura, restablezca la energía en el disyuntor.

5. Operación

5.1 Aiming the Light

The TK-103LED track head allows for flexible light direction. You can rotate the fixture 350 degrees horizontally and tilt it 90 degrees vertically to illuminate your desired area. Loosen the aiming screws slightly, adjust the fixture, and then re-tighten the screws to secure its position.

5.2 Atenuación

This fixture is designed for smooth and continuous dimming from 100% down to 1% when used with an electronic low voltage (ELV) dimmer. For optimal performance and to avoid flickering, ensure your dimmer switch is compatible with LED lighting and specifically with ELV dimming protocols.

6. Mantenimiento

6.1 Limpieza

To clean the fixture, ensure power is off. Wipe with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these may damage the finish or electrical components.

6.2 Re-Lamping (Bulb Replacement)

The TK-103LED track head uses a GU10 LED bulb. While the included LED bulb has a long lifespan, it can be replaced if necessary. The fixture is designed for easy re-lamping from the front without the use of tools. To replace the bulb:

1. Apague la energía del artefacto en el disyuntor.
2. Carefully grasp the decorative glass shade or the bulb itself and twist counter-clockwise to remove the GU10 bulb.
3. Insert a new GU10 LED bulb by aligning the pins with the socket holes and twisting clockwise until secure.
4. Restaure la energía al dispositivo.

7. Solución de problemas

8. Especificaciones

• Marca: Iluminación WAC
• Número de modelo: LTK-103LED-BK
• Color: Negro
• Material: Aluminum (fixture), Glass (shade)
• Estilo: L Track (compatible with H, J/J2 track types)
• Usos específicos: Uso en interiores únicamente
• Fuente de energía: AC
• Fuente de luz: CONDUJO
• Número de fuentes de luz: 1
• Volumentage: 120 voltios
• Quétage: 8 vatios
• Base de la bombilla: GU10
• Tipo de interruptor: Dimmer compatible (ELV LED)
• Brillo: 470 lúmenes
• Tipo de montaje: Montaje en el techo
• Dimensiones del artículo (largo x ancho x alto): 2.63" x 3.63" x 5.44" (Note: Height varies with aiming, refer to Figure 1 for detailed dimensions)
• Peso del artículo: 4.32 onzas
• Código postal: 790576225050

9. Garantía y soporte

9.1 Garantía del fabricante

WAC Lighting provides a warranty for this product: 5 years for functional components and 2 years for the finish. Please retain your proof of purchase for warranty claims.

9.2 Atención al cliente

For technical assistance, replacement parts, or warranty inquiries, please contact WAC Lighting customer support. Refer to the WAC Lighting webSitio o embalaje del producto para obtener información de contacto actualizada.