1. Introducción
This manual provides detailed instructions for the installation, operation, and maintenance of your Urmet Bibus Comfort 1172/45 intercom system. This system is designed to provide reliable communication and door entry control, featuring 6 distinct melodies for call signaling. Please read this manual thoroughly before attempting installation or operation to ensure proper function and safety.
2. Información de seguridad
Observe siempre las siguientes precauciones de seguridad para evitar lesiones y daños al dispositivo:
- La instalación debe ser realizada por un electricista calificado de acuerdo con los códigos eléctricos locales.
- Desconecte la alimentación antes de realizar cualquier instalación, mantenimiento o solución de problemas.
- No exponga el dispositivo a la humedad, temperaturas extremas o luz solar directa.
- No intente abrir ni reparar el dispositivo usted mismo. Encargue cualquier reparación a personal cualificado.
- Use only Urmet approved accessories and spare parts.
3. Contenido del paquete
Verifique que todos los artículos estén presentes en el paquete:
- Urmet Bibus Comfort 1172/45 Intercom Unit
- Soporte de montaje
- Tornillos de montaje y tacos de pared
- Manual de usuario (este documento)
Figure 1: Urmet Bibus Comfort 1172/45 Intercom Unit. This image displays the main intercom unit, typically a rectangular device with a speaker, microphone, and call button, designed for indoor use.
4. Configuración e instalación
Follow these steps for proper installation of the Urmet Bibus Comfort 1172/45 intercom system:
- Preparación: Ensure the power supply to the installation area is disconnected at the main circuit breaker.
- Montaje:
- Select a suitable indoor location, away from direct heat sources or moisture.
- Utilice el soporte de montaje como plantilla para marcar los puntos de perforación en la pared.
- Drill holes and insert wall plugs. Secure the mounting bracket to the wall using the provided screws.
- Alambrado:
- Connect the system wiring to the terminals on the intercom unit according to the wiring diagram provided in the separate installation guide (if applicable) or on the unit itself. Pay close attention to polarity.
- Asegúrese de que todas las conexiones estén seguras y aisladas.
- Montaje final: Carefully attach the intercom unit to the mounted bracket, ensuring it clicks securely into place.
- Encendido: Restore power to the system. The unit should power on, indicated by a status light (if present).
5. Instrucciones de funcionamiento
The Urmet Bibus Comfort 1172/45 is designed for straightforward operation:
5.1 Recibir una llamada
- When a visitor presses the call button on the outdoor unit, the indoor intercom unit will ring with one of the 6 pre-programmed melodies.
- To answer the call, lift the handset (if applicable) or press the talk button.
- To end the call, replace the handset or press the talk button again.
5.2 Apertura de la puerta
To open the door for a visitor:
- During an active call, press the door release button (usually marked with a key symbol).
- The door will unlock for a short period, allowing the visitor to enter.
5.3 Melody Selection (if applicable)
Some models allow selection of the ringing melody. Refer to the specific controls on your unit. Typically, a small switch or button allows cycling through the 6 available melodies.
6. Mantenimiento
The Urmet Bibus Comfort 1172/45 requires minimal maintenance:
- Limpieza: Wipe the unit with a soft, dry cloth. Do not use abrasive cleaners, solvents, or excessive moisture.
- Inspección: Periodically check for loose connections or visible damage. If any damage is found, disconnect power and contact a qualified technician.
7. Solución de problemas
If you encounter issues with your intercom system, refer to the following table:
| Problema | Posible causa | Solución |
|---|---|---|
| No sound from intercom unit. | No power; loose wiring; faulty unit. | Check power supply; verify wiring connections; contact support if unit is faulty. |
| La apertura de la puerta no funciona. | Wiring issue to door strike; faulty door strike; faulty intercom unit. | Check wiring to door strike; test door strike independently; contact support. |
| Intercom rings continuously or not at all. | Stuck call button on outdoor unit; wiring fault; unit malfunction. | Inspect outdoor unit button; check wiring; contact support. |
If the problem persists after attempting these solutions, please contact Urmet customer support.
8. Especificaciones
- Modelo: Urmet Bibus Comfort 1172/45
- Melodías: 6 seleccionables
- Fuente de alimentación: (Typically 12-24V AC/DC, specific to Bibus system - information not provided)
- Dimensiones: (information not provided)
- Peso: Approximately 150 kg (Note: This weight from product data is unusually high for an intercom unit and may be a data entry error. Please refer to the product packaging for accurate weight information.)
- Temperatura de funcionamiento: (information not provided)
Note: The listed item weight of 150 kg from the product specifications is unusually high for an intercom unit and may be a data entry error. Please refer to the product packaging for accurate weight information.
9. Garantía y soporte
Urmet products are covered by a limited warranty. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Urmet website. For technical support, spare parts, or service inquiries, please contact your local Urmet distributor or customer service center.
Urmet Customer Service:
- Websitio: www.urmet.com
- Información del contacto: Consulte la webSitio para detalles de contacto regionales.
