1. Producto terminadoview
The GAMEMAX H605-TA is a compact Micro ATX mid-tower PC case designed for users seeking a space-saving solution without compromising on aesthetics or functionality. It features 4mm tempered glass panels on the front and side, providing a clear view of internal components. The case includes three pre-installed RGB fans with addressable LEDs and a remote control for customizable lighting effects. Its robust 0.6mm chassis supports Micro ATX and ITX motherboards, offering ample space for essential components.
Figura 1: Frente y lateral view of the GAMEMAX H605-TA PC Case.
2. Configuración e instalación
This section provides instructions for installing your components into the GAMEMAX H605-TA PC case.
2.1 Conexiones del panel de E/S frontal
The front I/O panel provides convenient access to essential ports and controls. Connect these cables to the corresponding headers on your motherboard.
Figure 2: Front I/O Panel Layout. Includes Power Button, Reset Button, Mic and HD Audio Interface, USB 2.0 ports, and USB 3.0 port.
- Botón de encendido: Used to power on/off the system.
- Botón de reinicio: Used to restart the system.
- Puertos USB 2.0 (x2): Para conectar dispositivos USB 2.0.
- Puerto USB 3.0 (x1): For connecting USB 3.0 devices, offering faster data transfer.
- Mic and HD Audio Interface: Para conectar auriculares y micrófonos.
2.2 Motherboard and Power Supply Installation
The H605-TA supports Micro ATX and ITX motherboards. The power supply unit (PSU) is mounted at the bottom of the case.
- Remove the side tempered glass panel by unscrewing the four thumb screws.
- Instale el protector de E/S provisto con su placa base en la abertura trasera de la carcasa.
- Carefully place your Micro ATX or ITX motherboard onto the standoffs inside the case and secure it with screws.
- Install your ATX power supply into the dedicated compartment at the bottom rear of the case and secure it with screws.
Figure 3: Internal layout of the case, highlighting the motherboard mounting area and PSU shroud.
2.3 Instalación de la unidad
The case provides bays for both 3.5-inch HDDs and 2.5-inch SSDs.
- Discos duros de 3.5 pulgadas: Two internal drive bays are located beneath the PSU shroud. Slide your HDDs into the trays and secure them.
- SSD de 2.5 pulgadas: Two internal drive bays are available, typically mounted on the back of the motherboard tray or on the PSU shroud. Secure your SSDs with screws.
Figura 4: View of the internal 3.5-inch HDD drive bays (blue trays).
2.4 Instalación de la tarjeta gráfica
The case includes a support bracket for your graphics card to prevent sagging.
- Retire las cubiertas de las ranuras PCI necesarias de la parte trasera de la carcasa.
- Insert your graphics card into the appropriate PCI-E slot on your motherboard and secure it with a screw.
- Adjust the graphics card support bracket to hold the card firmly in place.
Figure 5: Adjustable graphic card support bracket inside the case.
3. Instrucciones de funcionamiento
Una vez que todos los componentes estén instalados y los cables conectados, puede encender su sistema.
3.1 Encendido / Apagado
Press the power button on the front I/O panel to turn on your computer. To turn it off, use the operating system's shutdown function or press and hold the power button for a few seconds.
3.2 Control del ventilador RGB
The GAMEMAX H605-TA includes three pre-installed RGB fans with addressable LEDs. These can be controlled using the provided remote control to adjust colors and lighting effects.
Figure 6: The included remote control for RGB fan customization.
- Point the remote control towards the RGB controller inside the case.
- Use the buttons on the remote to cycle through different colors, lighting modes, and adjust brightness or speed of effects.
4. Mantenimiento
El mantenimiento regular ayuda a garantizar un rendimiento óptimo y la longevidad de la carcasa y los componentes de su PC.
- Filtros de polvo: The top panel features a magnetic dust filter. Regularly remove and clean this filter to prevent dust buildup inside the case.
- Paneles de vidrio templado: Limpie los paneles de vidrio templado con un paño suave que no deje pelusa y un limpiacristales. Evite materiales abrasivos que puedan rayar el vidrio.
- Limpieza Interna: Abra la caja periódicamente y utilice aire comprimido para eliminar el polvo de los ventiladores, disipadores y otros componentes. Asegúrese de que el sistema esté apagado y desenchufado antes de limpiarlo.
5. Solución de problemas
If you encounter issues with your PC case, consider the following basic troubleshooting steps:
- El sistema no se enciende:
- Ensure the power supply is properly connected to the wall outlet and switched on.
- Verify that the power button cable from the front I/O panel is correctly connected to the motherboard's front panel header.
- Verifique todas las conexiones de alimentación internas (ATX de 24 pines, alimentación de CPU, alimentación de GPU).
- Los ventiladores no giran / El RGB no funciona:
- Ensure fan power cables are securely connected to the motherboard or fan controller.
- Verify that the RGB controller is receiving power and that RGB cables are correctly connected to the fans.
- Verifique la batería del control remoto si corresponde.
- Los puertos USB no funcionan:
- Confirm that the USB headers from the front I/O panel are correctly plugged into the motherboard.
6. Especificaciones
| Característica | Especificación |
|---|---|
| Tipo de caso | Torre media Micro ATX |
| Dimensiones (alto x ancho x profundidad) | 410 mm x 193 mm x 390 mm |
| Grosor del chasis | 0.6 mm |
| Material | Tempered Glass (Front & Side), Steel |
| Soporte de placa base | Micro ATX, ITX |
| Tipo de PSU | ATX (montaje inferior) |
| Ranuras de expansión | 4 x PCI Slots |
| Bahías de unidad | 2 disco duro de 3.5", 2 SSD de 2.5" |
| Puertos de E / S frontales | 2 x USB 2.0, 1 x USB 3.0, 1 x PS/2 Audio, 1 x PS/2 Microphone |
| Ventiladores preinstalados | Front: 2 x 120mm RGB, Rear: 1 x 120mm RGB |
| Apoyo de los fans | Delantero: 2 x 120 mm, Trasero: 1 x 120 mm |
| Soporte de refrigeración por agua | Rear: 1 x 120mm Radiator |
| Características especiales | Tempered Glass Panels, RGB Lighting with Remote Control, Magnetic Dust Filter, VGA Support Bracket |
7. Garantía y soporte
7.1 Información de garantía
The GAMEMAX H605-TA PC Case comes with a Garantía de 12 meses Desde la fecha de compra. Esta garantía cubre defectos de fabricación y defectos de material en condiciones normales de uso. No cubre daños causados por mal uso, accidentes, modificaciones no autorizadas o instalación incorrecta.
7.2 Soporte técnico
For technical assistance, troubleshooting beyond this manual, or warranty claims, please contact your retailer or the official GAMEMAX support channels. Please have your product model number (H605-TA) and proof of purchase ready when contacting support.