Manual del usuario del filtro de aire DryFlow AEM AE-07082

Producto terminadoview

The AEM DryFlow Air Filter is a high-performance, washable, and reusable synthetic air filter designed to optimize airflow and filtration for your vehicle. It requires no oil for maintenance, simplifying the cleaning process and ensuring durable service.

Image: AEM AE-07082 DryFlow Air Filter, showcasing its rectangular shape and red filter media.

Características principales

• Designed to increase horsepower and throttle response.
• Captures up to 99% of harmful contaminants.
• Offers outstanding performance even in dusty racing conditions.
• Fabricado en USA.

Imagen: Detallada view of the AEM DryFlow Air Filter highlighting its key components: 1. Dryflow Air Filter (synthetic media, no oil required), 2. OE Specific Molding (creates a tight seal), and 3. Aluminum Wire Meshing (straightens and smooths airflow).

Image: A white car on a road, representing the filter's design to increase horsepower.

Image: Close-up of the filter media, emphasizing that the product is 'MADE IN THE USA'.

Instalación

This section provides general guidance for installing your AEM DryFlow Air Filter. For detailed, vehicle-specific instructions, please refer to the official installation manual provided by AEM.

Descargar Manual de Instalación Oficial (PDF)

Pasos generales de instalación

1. Locate your vehicle's airbox.
2. Open the airbox and carefully remove the existing air filter.
3. Insert the AEM DryFlow Air Filter into the airbox, ensuring the OE Specific Molding creates a tight seal.
4. Close and secure the airbox lid.
5. Verifique que todas las conexiones estén seguras antes de operar el vehículo.

Image: A hand demonstrating the ease of installation by placing the AEM DryFlow Air Filter into a vehicle's airbox.

Mantenimiento

The AEM DryFlow Air Filter is designed for easy maintenance and long service life. Unlike oiled filters, it requires no oil for cleaning.

Instrucciones de limpieza

1. Remove the air filter from the vehicle's airbox.
2. Gently tap the filter to dislodge any loose debris.
3. Rinse the filter with water from the clean side (inside) to the dirty side (outside) to push contaminants out.
4. Use a mild, non-foaming detergent if necessary, and rinse thoroughly.
5. Allow the filter to air dry completely before reinstallation. Do not use compressed air or heat to dry, as this may damage the filter media.

Image: The AEM DryFlow Air Filter being cleaned with water, demonstrating its washable and reusable nature without requiring oil.

Regular cleaning ensures optimal airflow and filtration performance.

Presupuesto

Imagen: Primer plano view of the thick 3D media, designed for increased airflow and dirt capacity.

Solución de problemas

If you encounter issues with your AEM DryFlow Air Filter, consider the following common troubleshooting steps:

• Rendimiento reducido: Ensure the filter is clean and free of excessive debris. A clogged filter can restrict airflow. Verify the filter is properly seated in the airbox, creating a tight seal.
• Ruidos inusuales: Check for proper installation. An improperly seated filter or airbox lid can cause air leaks and unusual sounds.
• Luz de verificación del motor: While rare, an improperly installed air filter or a damaged Mass Air Flow (MAF) sensor during installation can trigger a check engine light. Re-check installation and consult a professional if the light persists.
• Daños en el filtro: Inspect the filter for any tears or damage to the media or molding. A damaged filter should be replaced to ensure proper filtration.

For persistent issues or specific technical support, please contact AEM customer service.

Garantía y soporte

AEM products are manufactured to high standards. For information regarding product warranty, claims, or technical support, please refer to the official AEM websitio o comuníquese directamente con su departamento de atención al cliente.

Visit AEM Official Websitio