1. Introducción
This manual provides essential information for the proper installation, operation, and maintenance of your AXA Blueline 80 Rear Light. Please read this manual thoroughly before using the product to ensure safe and efficient operation. The Blueline Steady is designed to fit lighter and slimmer looking bikes perfectly, offering reliable rear illumination.
2. Información de seguridad
- Asegúrese siempre que la luz esté montada de forma segura antes de empezar a conducir.
- Regularly check the light for damage or loose connections.
- Do not attempt to disassemble the light housing, as this may void the warranty and compromise water resistance.
- Ensure the light is clean and free from obstructions to maintain optimal visibility.
- This light is designed for bicycle use only.
3. Contenido del paquete
Verifique que todos los componentes estén presentes en el paquete:
- AXA Blueline 80 Rear Light (1 unit)
- Mounting hardware (if applicable, typically integrated with luggage rack mount)
4. Configuración e instalación
The AXA Blueline 80 Rear Light is designed for mounting on a bicycle's luggage rack and is dynamo-powered. Ensure your bicycle has a compatible dynamo system (hub or side dynamo).
4.1 Montaje de la luz trasera
- Identify the mounting points on your bicycle's luggage rack. The Blueline 80 typically uses an 80mm bolt spacing for mounting.
- Align the light with the mounting holes on the luggage rack.
- Secure the light using appropriate screws and nuts (not always included, may use existing rack hardware). Ensure the light is firmly attached and does not wobble.
Imagen: Lateral view of the AXA Blueline 80 Rear Light securely mounted on a bicycle's luggage rack, demonstrating its slim profile y la integración.
Imagen: Trasera view of the AXA Blueline 80 Rear Light installed on a bicycle, highlighting the integrated reflector and the light's position for optimal visibility.
4.2 Electrical Connection (Dynamo)
The Blueline 80 is dynamo-powered. Connect the light to your bicycle's dynamo system:
- Locate the power input terminals on the rear light, typically at the bottom. These are usually marked with '+' and '-' or similar indicators.
- Connect the positive wire from your dynamo to the '+' terminal of the light.
- Connect the negative (ground) wire from your dynamo to the '-' terminal of the light.
- Asegúrese de que todas las conexiones estén seguras y protegidas de la humedad.
Imagen: Frente view of the AXA Blueline 80 Rear Light, illustrating its design and the integrated reflector for passive safety.
5. Instrucciones de funcionamiento
The AXA Blueline 80 Rear Light operates automatically once connected to a functioning dynamo system.
5.1 Operación automática
- The light features an automatic light/dark sensor. It will activate automatically when ambient light levels are low and the bicycle is in motion (generating power from the dynamo).
- The light includes a 'Steady' function, which keeps the light illuminated for approximately 4 minutes when the bicycle is standing still, providing continued visibility at stops.
Image: The AXA Blueline 80 Rear Light in operation, demonstrating its bright red LED illumination for enhanced visibility.
6. Mantenimiento
The AXA Blueline 80 Rear Light is designed for low maintenance. Follow these guidelines to ensure longevity and optimal performance:
- Limpieza: Limpie la superficie de la luz con un paño suave.amp cloth to remove dirt and grime. Avoid abrasive cleaners or solvents.
- Vida útil LED: The high-power LED light has a lifespan of more than 50,000 hours, meaning replacement is generally not required under normal use.
- Resistencia al agua: The light is water-resistant (IP65 rated). While it can withstand splashes and rain, avoid submerging it in water.
- Conexiones: Periodically check the electrical connections to the dynamo to ensure they remain secure and free from corrosion.
7. Solución de problemas
If you experience issues with your AXA Blueline 80 Rear Light, consult the following table:
| Problema | Posible causa | Solución |
|---|---|---|
| La luz no se enciende. | No power from dynamo; loose electrical connection; ambient light too high. | Ensure bicycle is in motion; check dynamo function; verify all electrical connections are secure; test in darker conditions. |
| La luz es tenue o parpadea. | Insufficient power from dynamo; poor electrical connection; dirt on light surface. | Ensure consistent speed for dynamo; check and clean electrical contacts; clean the light's lens. |
| Light does not stay on when stopped. | Issue with the 'Steady' function capacitor or circuit. | Si el problema persiste después de verificar la energía, comuníquese con el servicio de atención al cliente. |
8. Especificaciones
Key technical specifications for the AXA Blueline 80 Rear Light:
| Característica | Detalle |
|---|---|
| Nombre del modelo | línea azul 80 |
| Número de pieza | LAA030 |
| Color | Rojo |
| Material | Plástico |
| Fuente de poder | Dynamo Powered (Hub and Side Dynamo compatible) |
| Brillo | 50 Lux (front light equivalent, for rear light this refers to intensity) |
| Nivel de resistencia al agua | Resistente al agua (IP65) |
| Peso del artículo | 60 gramos |
| Dimensiones del producto (LxAnxAl) | 3.94" x 1.18" x 1.18" (10 cm x 3 cm x 3 cm) |
| Tipo de montaje | Luggage Rack Mount (80mm bolt spacing) |
| Características especiales | Steady light (4 minutes when standing still), Automatic light/dark sensor, Integrated retro reflector |
| Vida útil del LED | Más de 50,000 horas |
9. Garantía y soporte
9.1 Información de garantía
The AXA Blueline 80 Rear Light comes with a Garantía del fabricante de 2 añosEsta garantía cubre defectos de materiales y mano de obra en condiciones normales de uso. No cubre daños causados por mal uso, accidentes, modificaciones no autorizadas ni desgaste normal. Conserve su comprobante de compra para reclamaciones de garantía.
9.2 Atención al cliente
For technical assistance, warranty claims, or further inquiries, please contact your retailer or the official AXA customer support channels. Refer to the AXA webSitio para obtener la información de contacto más actualizada.
