1. Información importante de seguridad
Read all instructions before installing or using this heater. Failure to follow these instructions may result in fire, electric shock, serious injury, or death.
- Protección eléctrica: Protect the unit with appropriate circuit breakers or fuses as per the nameplate specifications.
- VolumentagCompatibilidad: Asegúrese de que el volumen de suministrotage (volts) matches the rating indicated on the heater's nameplate.
- Toma de tierra: Esta unidad debe estar correctamente conectada a tierra.
- Alambrado: Use copper conductors only. Power leads must be suitable for 75°C (167°F).
- Desconexión de energía: Always switch off the power supply to the unit at the circuit breaker/fuse before any installation, repair, or cleaning.
- Uso previsto: Verify that the heater is suitable for its intended application. Consult the product catalog or a representative if unsure.
- Capacidad de calefacción recomendada: For optimal performance, a heating capacity of 1.25 W per cubic foot (0.03 m³) is recommended.
2. Producto terminadoview
The Uniwatt by Stelpro UHC1002W is a modern, surface-mounted convector heater designed for quiet and efficient heating. It features a durable 22-gauge steel cabinet and an integrated electronic thermostat for precise temperature control.
Frente view of the Uniwatt by Stelpro UHC1002W Convector Heater.
Lado view ilustrando el delgado profile of the convector heater.
Detail of the effective heating elements: two stainless steel tubular sheathed elements isolated with nylon sleeves to reduce expansion and contraction noises.
The heater's design promotes efficient airflow, drawing cool air from below and expelling warm air through the front grille, creating a chimney effect for consistent heat distribution.
3. Instrucciones de instalación
This heater is designed for surface or wall-mounted installation. Ensure power is disconnected at the circuit breaker before beginning installation.
3.1 Montaje
- The heater must be mounted with a minimum clearance of 4 inches (10 cm) from the floor.
- Utilize the concealed mounting bracket for a secure and tidy installation.
Image illustrating the concealed mounting bracket for wall installation.
3.2 Conexión eléctrica
- The heater requires a 240V hardwired connection.
- Use the back entry plate with cable clamps for a secure and organized wiring setup within the junction box.
- All wiring must comply with local electrical codes and regulations.
Diagram showing a typical 240V hardwired connection within a junction box.
4. Instrucciones de funcionamiento
The Uniwatt UHC1002W heater features a built-in electronic thermostat for precise temperature control and energy optimization.
4.1 Configuración de la temperatura
- Use the control buttons adjacent to the digital display to adjust the desired room temperature.
- The electronic thermostat will maintain the set temperature, cycling the heater on and off as needed.
De cerca view of the integrated electronic thermostat display and control buttons.
5. Mantenimiento
Regular maintenance ensures optimal performance and longevity of your heater. Always disconnect power at the circuit breaker before performing any maintenance.
5.1 Limpieza
- Limpie el exterior del calentador con un paño suave yamp Paño. No utilice limpiadores abrasivos ni disolventes.
- Ensure the air intake and exhaust grilles are free from dust and debris to maintain proper airflow.
6. Solución de problemas
If you experience issues with your Uniwatt convector heater, consult the following table for common problems and solutions.
| Problema | Posible causa | Solución |
|---|---|---|
| El calentador no enciende | No power supply; Circuit breaker tripped; Thermostat set too low | Check circuit breaker; Ensure power is on; Increase thermostat setting |
| Calefacción insuficiente | Thermostat set too low; Obstruction of air grilles; Heater size inadequate for room | Increase thermostat setting; Clear grilles; Refer to heating capacity guidelines |
| Ruidos inusuales | Dust or debris inside unit; Loose mounting | Disconnect power and inspect/clean; Ensure heater is securely mounted |
Si el problema persiste después de intentar estas soluciones, comuníquese con el servicio de atención al cliente.
7. Especificaciones
| Característica | Detalle |
|---|---|
| Marca | Stelpro (Uniwatt) |
| Número de modelo | UHC1002W |
| potencia/vatiotage | 1000 vatios |
| Volumentage | 240 voltios |
| Material | Acero calibre 22 |
| Color | Blanco |
| Dimensiones del producto | 58.1 x 10 x 44.61 cm (22 7/8" W x 3 7/32" D x 17 9/16" H) |
| Peso del artículo | 6.03 kilogramos |
| Características especiales | Built-in Electronic Thermostat |
| Tipo de montaje | Montaje en pared (superficie) |
| Uso en interiores y exteriores | Interior |
| Método de calentamiento | Convección |
Dimensional diagram of the Uniwatt convector heater.
Indication that the product is proudly made in Canada.
8. Garantía y soporte
8.1 Garantía
This Uniwatt by Stelpro convector heater comes with a 2 año de garantía a partir de la fecha de compra, cubriendo defectos de material y mano de obra en condiciones normales de uso.
8.2 Atención al cliente
For technical assistance, warranty claims, or any questions regarding your heater, please contact Stelpro customer service:
- Teléfono: 1-844-783-5776
- Correo electrónico: info@stelpro.com
- DIRECCIÓN: 1041 Rue Parent, Saint-Bruno-de-Montarville, QC J3V 6L7
