KeylessOption Keyless Entry Remote Starter Car Key Fob User Manual

Introducción

This manual provides comprehensive instructions for the KeylessOption Keyless Entry Remote Starter Car Key Fob. This remote is designed as a replacement for aftermarket Viper alarm and remote start systems. Ensure your original remote's FCC ID matches EZSDEI7141 for compatibility.

Imagen: Frente view of the KeylessOption Key Fob, displaying the lock, unlock, AUX, and star buttons.

Configuración y Programación

Programming this remote requires locating the Viper system's control button, often found near the rearview mirror, under the dashboard, or in other discreet locations depending on the installation. Refer to your vehicle's specific Viper system manual or consult a professional if you cannot locate it.

Pasos de programación:

1. Open the driver's side door of your vehicle.
2. Insert the key into the ignition and turn it to the ON position. Do not start the engine.
3. Locate the Viper system's control button (often a small button with a blue LED indicator).
4. Presione el botón de control siete veces. En el eighth press, hold the button down until the car chirps.
5. While still holding the control button, press the Cerrar button on your new KeylessOption remote. The car should chirp again to confirm successful programming.
6. Suelta el botón de control.
7. Gire la llave de encendido a la APAGADO posición y retírelo.
8. Close the driver's side door.
9. Test the remote's functions (Lock, Unlock, etc.) to ensure proper operation.

If you are programming multiple remotes, repeat steps 4 and 5 for each additional remote before turning the key off in step 6.

Vídeo: Un breve resumenview of KeylessOption Key Fob Remotes for Viper systems.

Instrucciones de funcionamiento

Once programmed, your KeylessOption remote provides convenient control over your vehicle's aftermarket alarm and remote start system. The remote features four distinct buttons:

• Botón de bloqueo: Press to lock your vehicle's doors and arm the alarm system.
• Botón de desbloqueo: Press to unlock your vehicle's doors and disarm the alarm system.
• Botón AUX: This button typically controls auxiliary functions, such as opening the trunk or activating a remote start feature, depending on your Viper system's configuration. Refer to your Viper system's manual for specific AUX button functionality.
• Panic Button (*): Press and hold this button to activate the vehicle's panic alarm. Press again to deactivate.

Imagen: En ángulo view of the KeylessOption Key Fob, highlighting its ergonomic design.

Mantenimiento

Reemplazo de batería:

If your remote's range decreases or it stops responding, the battery may need replacement. The KeylessOption remote uses a standard coin cell battery (e.g., CR2032, check inside the remote for exact type). To replace:

1. Separe con cuidado las dos mitades del control remoto.asing utilizando un pequeño destornillador de punta plana o una herramienta de palanca.
2. Remove the old battery. Note its orientation (+/- sides).
3. Inserte la batería nueva con la orientación correcta.
4. Encaja el control remoto casinVuelva a colocarlos de forma segura.

Imagen: Parte posterior view of the KeylessOption Key Fob, indicating where the casing se puede abrir para acceder a la batería.

Solución de problemas

• El control remoto no responde: Ensure the battery is fresh and correctly installed. Re-attempt the programming steps carefully. Verify the FCC ID on your original remote matches EZSDEI7141.
• Rango limitado: Replace the battery. Ensure there are no obstructions between the remote and the vehicle's antenna.
• Vehicle not chirping during programming: Double-check that the ignition is in the ON position (not ACC or START). Confirm you are pressing the Viper control button the correct number of times and holding it on the last press until a chirp is heard.

Presupuesto

Garantía y soporte

Each KeylessOption remote includes a warranty card. KeylessOption is an automotive remote company dedicated to providing reliable replacement automotive products. For further assistance or warranty claims, please refer to the contact information provided on your warranty card or visit the official KeylessOption websitio.

Image: KeylessOption Warranty Card, included with each purchase.