Instalar el módulo de interfaz de red Cisco Catalyst
Esta sección proporciona información antes y durante la instalación de los módulos de interfaz de red (NIM) de Cisco Catalyst en las plataformas perimetrales de la serie Cisco Catalyst 8200.
Encimaview del módulo de interfaz de red
The Cisco Catalyst Network Interface Module (NIM) is supported on Cisco Catalyst 8200 Series Edge Platforms.
These are the steps to install a NIM:
1. Localice la ranura NIM en el panel frontal.
2. Loosen the screws to remove NIM blank cover.
3. Inserte el NIM en la ranura.
4. Apriete los tornillos para asegurar el NIM en la ranura.
These are the steps to remove a NIM:
1. If the NIM is up and running, issue the following command to shut down the NIM gracefully before removing it:
hw-module subslot slot 0/2 stop
Precaución If you do not shut down the NIM gracefully before removing it, the NIM card could get damaged.
2. Localice la ranura NIM en el panel frontal.
3. Afloje los tornillos que fijan el NIM.
4. Extraiga con cuidado el NIM de la ranura.
All module slots must have a module or blank installed for the product to work thermally and for safety purposes.
Para obtener información adicional, consulte la hoja de datos de Cisco Catalyst 8200 Series Edge Platforms en cisco.com para obtener una lista de NIM compatibles con las plataformas.
Quitar e instalar módulos de interfaz de red
Keep the following tools and equipment while working with the Network Interface Modules (NIM)s:
- Destornillador Phillips número 1 o un destornillador pequeño de punta plana
- Muñequera antiestática
Retire el módulo de interfaz de red
Paso 1 Shut down the electrical power to the slot in the device, turn off the electrical power to the device. Leave the power cable plugged-in to channel ESD voltages a tierra.
Paso 2 Remove all network cables from the rear panel of the device. Using a number 1 Phillips screwdriver, loosen the captive screws on the network interface module.
Paso 3 Slide the network interface module out.
Paso 4 If you are not replacing the module, install a blank faceplate over the empty slot to ensure proper air flow.
Instalar los módulos de interfaz de red Cisco Catalyst
Paso 1 Shut down the electrical power to the slot in the router by turning off the electrical power to the router. Leave the power cable plugged in to channel ESD voltages a tierra.
Paso 2 Remove all network cables from the rear panel of the device.
Paso 3 Remove the blank faceplates installed over the network interface module slot that you intend to use.
Nota Save blank faceplates for future use.
Paso 4 Align the module with the guides in the chassis walls or slot divider and slide it gently into the NIM slot on the device.
Paso 5 Push the module into place until you feel the edge connector seat securely into the connector on the router backplane. The module faceplate should contact the chassis rear panel.
Paso 6 Using a number 1 Phillips screwdriver, tighten the captive screws on the network interface module.
Paso 7 Connect the module to the network and re-enable the power to the slot in the device.
Instalar el módulo de interfaz de red Cisco Catalyst
Documentos / Recursos
 |
Módulo de interfaz de red Catalyst de la serie CISCO 8200 [pdf] Guía del usuario Serie 8200, Módulo de interfaz de red Catalyst serie 8200, Módulo de interfaz de red Catalyst, Módulo de interfaz de red, Módulo de interfaz |